Standard Plastic Enclosures | Cases, Housings & Kiosks

Sandwich Low-Profile Cases

Dilip Merani — Wed, 19 Feb 2025 17:34:09 +0000

Sandwich Low-Profile Cases consist of 2 halves machined from sheet-stock that is slightly thicker than half the thickness of the finished case. The cavity for the internal components is hogged out first before the CNC machine cuts the case perimeter. If needed, one or more frames can be fitted between the top and bottom layer to create a greater internal volume. Cases made in this fashion are extremely strong and are are often used to make rugged connector cases. Wands and sleeves for PCB antennas can also be made this way. Thick ABS sheet is the most common material

The post Sandwich Low-Profile Cases appeared first on Click Fold Plastics.

2-U Clamshell Housing

Dilip Merani — Wed, 19 Feb 2025 17:33:10 +0000

2-U Clamshell Housings consist of 2 U-shaped halves that either snap together (ideal for small enclosures) or that are held together by flat-head screws that are flush with the case. This is the simplest and most cost-effective way to create custom housings ranging from match-box to shoe-box in size. An added advantage is that the top and 2 sides can be printed on in one setup prior to forming the part. Typical uses include industrial controllers, transformers, transmitters, hubs and the like. ABS and PC-ABS are the preferred materials for these custom enclosures.

The post 2-U Clamshell Housing appeared first on Click Fold Plastics.

Table-Top Register and Kiosk

Dilip Merani — Wed, 19 Feb 2025 17:32:06 +0000

Table-Top Registers and Kiosks consist of a multi-bend main face which is capped by side panels. Bends can go both ways – inward and outward which allows for a multitude of contours for table-top housings made from plastic that require surfaces at different angles for displays, keyboards, touch pads or card readers. Its larger version is often deployed as a freestanding kiosk. Typical uses are check-in devices, lobby equipment, entry gate and ticketing kiosks. ABS, PC-ABS and for large units E-PVC are the preferred materials for these custom enclosures.

The post Table-Top Register and Kiosk appeared first on Click Fold Plastics.

Removable Front & Back Cases

Dilip Merani — Wed, 19 Feb 2025 17:31:24 +0000

Removable Front & Back Instrument Cases consist of a U-shaped top and bottom piece that capture and overlap the front and back panel. Because top and bottom are held together by internal side panels this 6-part design is extremely strong and does not rely on any solvent welds. Since all panels are removable this type of plastic enclosure is ideal for diagnostic devices that require frequent service. It compares favorably with cases made from extruded aluminum offering better access and more customization options. ABS and PC-ABS are the preferred materials.

The post Removable Front & Back Cases appeared first on Click Fold Plastics.

Slide-In Chassis Housing

Dilip Merani — Wed, 19 Feb 2025 17:30:01 +0000

Slide-In Chassis Housings consist of a 4-sided cover and an L-shaped slide-in chassis. This is ideal for circuit boards with protruding connectors on opposing sides because the PCB can be easily mounted to the chassis which is then slid into the 4-sided cover. Keyways minimize the need for fasteners and in many cases only a single flush-mount screw is needed to securely lock the 2 parts together. This is the most assembly-friendly solution for single PCB plastic housings. ABS and PC-ABS are the preferred materials for these custom enclosures.

The post Slide-In Chassis Housing appeared first on Click Fold Plastics.